RollerMate Mastmate mast raising system


Power Assisted Mast Raising System YouTube

MacGregor 25 Mast Raising System The mast can be easily raised single handedly using this or other variation on the same theme. Total cost of construction was less than $30, Parts needed: 1 1.5x1.5 x 7' aluminum square tubing, $7 1 1500' winch $15 1 block or as in my case a medium size $2.50 caster with wheel ground into a sheave.


GinPole Mast raising system Page 2 Community

After a rig refit, the mast of Sampaguita, a Pacific Seacraft Flicka 20, was ready to be raised. Still in her Port Townsend slip, the process was, generally, the opposite of lowering, presented in 'Lectronic Latitude on June 16, 2021 — Lowering the Mast on a Small Sailboat with The Resourceful Sailor. It required the same bridle setup.


The Perfect Solo MastRaising System for Small Sailboats Tropical Boating

It takes about a minute to raise and secure the mast. Mast Raising Sequence. (1) The mast is slid back along the stern brace into position and (2) the bolt is secured to the tabernackle. (3)The mast is bench pressed from the cockpit while the line connected to the forestay is pulled. (4) I leave the lower board on the cabin cover in place to.


The Perfect Solo MastRaising System for Small Sailboats Tropical Boating

0:00 / 11:48 Today I try and develop a mast raising system for my Macgregor sailboat.Please consider becoming a patron: https://www.patreon.com/SailingFreeStyleOr gratuit.


RollerMate Mastmate mast raising system

These instructions are specific to our 2002 Macgregor 26x, but should apply to other Macgregor sailboats as well. Tools needed. Two 9/16″ wrenches. Two 1/4″ wrenches. Mast raising pole, with bolt, line and block and tackle pulley system. Winch handle. Before starting, check the mast for damage and ensure the pulleys at the top of the mast.


Rise Up! How to Raise Your Sailboat Mast Good Old Boat

Mastender™ Pictorial Step 1 One person can lift the hinged mast from its rest position on the transom support, with the boat on the trailer or in the water. Side stays and halyards are already in position. Step 2 Insert the mast-hinge lock pin. The hinge has great strength. The stays provide all the support needed. Step 3


Home Made Mast Raising System! YouTube

266 Share 49K views 6 years ago Andrew Price explains how to use a gin pole and assemble tackle to raise and lower a sailboat mast. This is a 30' mast on an O'Day 26, and the gin pole was made.


Tanzer 16 Sailboat Mast Raising System in Action YouTube

With an electric remote winch or a line back to the mainsheet in the cockpit, Zeb lifts the mast with little or no side sway and the weight is controlled by the winch. Set up time would be less than two minutes for the rig that goes on the front of the mast, and no heavy lifting. Patience.


Mariner Mast Raising System Photo by SLHPHOTO1 Photobucket Sailing yacht, Sailing, Catamaran

0:00 / 10:46 DIY Sailboat Mast Raising System atomvoyager 11.3K subscribers Subscribe Subscribed 437 Share 25K views 2 years ago Here's a DIY demonstration of raising and lowering the 35'.


Sailboat Mast Raising System YouTube

The MK-II's came from the factory all set-up for Catalina's mast raising system. It uses a simple 8' gin-pole that slides into a hole at the base of the mast, and a couple baby-stays that slip into the mast with a "T"-fitting, and pelican hooks that attach to straps used to secure the halyard turning blocks to the cabin top. A couple fiddle.


Precision 21 Mast Raising System

Today I built and finished my mast raising system for my sailboat. This should make it faster setting up so I can get out sailing faster.Please Subscribe and.


Raising The Mast SEA SPRITE ASSOCIATION

Mast Up Sailboat Mast Raising System is an easy mast stepping device and supports your mast while trailering or storing. Now just 2 people can raise any mast. Ideal for short handed mast raising. Fits virtually any boat with an outboard rudder (see the Mast Up Cockpit version for through-hull rudder boats). Mast Up telescopes to 9-1/2 feet.


1972 C&C 27 MkI sailboat mast raising

After the mast has been positioned in the base bracket and "pinned": 1. Fasten a block on the bow of the boat. 2. Cleat the jib halyard to the mast. 3. Run the jib halyard thru the block on the bow. 4. Hold the free end of the jib halyard loosly in either hand. 5.


Gin Pole Mast Raising System PY23 Paceship.mov YouTube

The critical thing to understand about this mast-raising technique is that in order for the mast and gin-pole lines to stay tight and keep the mast and gin-pole centered over the boat, the bridles must have their pivot points located on an imaginary line running through the mast pivot bolt.


MAST RAISING SYSTEM COMPLETE! Sailing Meraki Ep.61 YouTube

Best single handed mast raising system ever


Precision 21 Mast Raising System Flickr

One is the mechanism for raising and lowering the mast and the other is a system for stabilizing the mast to prevent it from oscillating from side to side during the process. As it is being raised or lowered, the mast rotates around a pin in the mast step or tabernacle.